DELTA DORE D10 W RF - Thermostat For Heating Control Installation Manual

• Carefully read these instructions prior to installation.
• The unit must be installed in compliance with current standards.
• Always switch off the mains before installing or servicing the unit.
• Do not attempt to repair the unit yourself; after-sales service is available.
• Check that the fastenings are suitable for the surface to which the unit will be mounted (plasterboard, brick, etc.).
• The diagrams provided are simplified for greater clarity.
  Protections and other accessories required by standards are not illustrated.
  Standards and good practice must be complied with. Connected or nearby units must not generate excessive interference (Directive 2004/108/EC).

Technical characteristics

Transmitter D10 RF

• Power supply: 2 LR03-AAA type 1.5 V alkaline batteries
• Insulation class: class III
• Transmission frequency 868 MHz (Standard EN 300 220)
• Class 1 radio equipment (can be placed on the market and put into service without any restrictions)
• Radio range: 100 to 300 metres outside, varies depending on the equipment linked (the range can be altered depending on the installation conditions and the electromagnetic environment)
• Wireless remote control device
• PI (Proportion Integral) regulation
• Storage temperature: -10°C to +70°C
• Operating temperature: 0°C to +40°C
• Dimensions: 80 x 80 x 23 mm
• Protection rating: IP30
• Installation in an environment with normal pollution levels

Receiver RF 810

• 230 V, 50 Hz power supply, +/-10%,
• Consumption: 11 VA (P=1.2 W)
• Class II insulation
• Contact output 3 A max., 230 V Cos ϕ = 1
• Automatic action: 1.C (brownout),
• Radio frequency 868 MHz (standard EN 300 220)
• Wireless range: 100 to 300 metres outside, variable depending on the associated equipment (the range can vary depending on the installation conditions and the electromagnetic environment)
• Storage temperature: -10°C to +70°C
• Operating temperature: 0°C to +40°C
• Installation in an environment with normal pollution levels
• Screw mounting (standard Wallplate)
• Dimensions: 96 x 96 x 39 mm
• Protection rating: IP 40

Installing the RF 810 receiver

Connecting the RF 810 receiver

Example 1 230V powered output


Example 2 Dry contact output

Positioning the Radio D10

Associating the Radio D10 transmitter with the receiver

NOTE: You can manually reset the receiver by pressing the button of the channel to associate for 10 seconds until the LED flashes rapidly.

Configuring the Radio D10

The transmitter and the receiver are associated when delivered.
You may however need to reassociate your products after removing wireless associations for instance).

Troubleshooting

Nothing is displayed on the transmitter screen.
There is no power supply. Check the batteries.

No LEDs light up on the receiver.
The receiver is not powered.
Check the receiver's electrical connections.

The receiver does not accept commands from the transmitter.

• The transmitter is not associated with the receiver. Repeat the association procedure.
• The transmitter batteries are low. Change the transmitter batteries.
• Radio transmission is not optimal. Transmission quality depends on the installation conditions and environment (type of wall, location, etc.).

The icon appears.
Battery level is low.
Change the batteries, ensuring they are in the correct position.

Delta Dore hereby declares that the equipment complies with the essential requirements and other relevant provisions of the R&TTE Directive 1999/5/EC.
The EC declaration of conformity for this equipment is available, on request, from: "Technical info" department
DELTA DORE - Bonnemain - 35270 Combourg (France)
Email: info.techniques@deltadore.com
Because of changes in standards and equipment, the characteristics given in the text and the illustrations in this document are not binding unless confirmed.