Installing The Receiver; Location; Mounting / Connection; Wireless Pairing - DELTA DORE Tybox 5701FP Quick Start Manual

2. Installing the receiver

2.1 Location

The antenna of the receiver must be clear of any
metallic surface.

2.2 Mounting / Connection

❶ First of all, switch off the power to your setup.
❷ The receiver can be secured by suitably sized
screws or by adhesive (supplied).
❸ You must make sure you comply with the wire
colours when wiring.
Blue: Neutral
Brown: Phase
Black: Pilot wire
Grey: control by load-shedder
❹ Once the receiver is connected, turn on the
power to your setup.
Important:
• If there is no load-shedder, the grey wire cannot
be connected, however, it is preferable that it
be electrically isolated (on a terminal block, for
example).
• The power cable for this product cannot be
replaced; if the cable is damaged, the device
must be disposed of.

3. Wireless pairing

1
2
>3s
... ... ...
The first time you power up, the green LED light on the
receiver flashes rapidly, indicating that it has not been
paired.
❶ To pair it, press the receiver button for 3 seconds,
until the red LED flashes. Release the button.
❷ On the Tybox, press and hold both the mode and +
buttons for 3 seconds.
The screen will display rF00. Release the button.
mode
3
>3s
OFF
230V~
50 Hz
ON
N
L
4
❸ Press briefly on +. The screen flashes until rF
is displayed depending on the number of paired
receivers(❹) (eg. rF01 for a single receiver, rF02 for 2
receivers etc.).
❺ Check that the LED of the receiver(s) is no longer
flashing.
To exit the mode, simultaneously and briefly press the
mode and + buttons.
50 m max.
x 2 max.
5
OFF
mode
EXIT
3