Installing The Receiver; Location; Mounting / Connection; Pairing The Receiver To The Transmitter - DELTA DORE Tybox 5701 FP Installation And User Manual

2. Installing the receiver

2.1 Location

mode
The antenna of the receiver must be clear of any
~1,50 m
metallic surface.

2.2 Mounting / Connection

❶ First of all, switch off the power to your setup.
> 20 cm
❷ The receiver can be secured by suitably sized
screws or by adhesive (supplied).
❸ You must make sure you comply with the wire
colours when wiring.
Blue: Neutral
Brown: Phase
Black: Pilot wire
Grey: control by load-shedder
❹ Once the receiver is connected, turn on the
power to your setup.
Important:
• If there is no load-shedder, the grey wire cannot
be connected, however, it is preferable that it
be electrically isolated (on a terminal block, for
2 x 1,5V - AAA LR03
example).
• The power cable for this product cannot be Click
replaced; if the cable is damaged, please
contact your reseller.
Click

3. Pairing the receiver to the transmitter

1
>3s
... ... ...
The first time you power up, the
green LED light on the receiver
flashes rapidly, indicating that it has
not been paired.
❶ To pair it, press the receiver
button for 3 seconds, until the red
LED flashes. Release the button.
mode
mode
mode
2 x 1,5V - AAA LR03
Click
Click
mode
mode
2
>3s
❷ On the Tybox, press and hold
both the mode and + buttons for
3 seconds. The screen will display
rF00. Release the button.
❸ Press briefly on +. The screen
flashes until rF is displayed
depending on the number of paired
receivers (eg. rF01 for a single
receiver, rF02 for 2 receivers etc.).
OFF
230V~
50 Hz
N
L
3
❹ Check that the LED of the
receiver(s) is no longer flashing.
To exit the mode, simultaneously
and briefly press the mode and +
buttons.
ON
50 m max.
x 2 max.
OFF
mode
4
4