Rear Panel And Connectors Inside The Lower Front Panel - Panasonic AJ-HPD2500P Operating Instructions Manual

Rear Panel and Connectors Inside the Lower Front Panel

1
1.
Fan
Cools this unit. Install the unit making sure that the air
vents are not blocked. If the fan stops due to a
breakdown, "E-10" will appear on the counter display.
While the unit will operate even when the fan has
stopped, it should be shut down immediately.
2.
SERIAL DIGITAL COMPONENT AUDIO and VIDEO
IN/OUT connectors
I/O connector for digital component audio and video data.
The SD-SDI MONITOR connector outputs video
signals with superimposed data.
Use setup menu No.005 (SUPER) and the SUPER
switch at the top of the front panel to turn
superimposing on or off.
◆ NOTE:
• The SD SDI MONITOR connector always outputs 480/
59.94i or 576/50i signals.
• The input digital audio signals must be synchronized with
the video input signals. Otherwise, the audio signals will be
affected by noise.
• Use a 5C-FB compatible double-shielded cable for
connection to the SERIAL DIGTAL COMPONET connector.
3.
DIGITAL AUDIO IN/OUT connectors
This connector inputs and outputs digital audio signals
compliant with the AES/EBU standard.
◆ NOTE:
• The input digital audio signals must be synchronized with
the video input signals. Otherwise, the audio signals will be
affected by noise.
• Use double shielded cable for making connections to
DIGITAL AUDIO IN/OUT connectors.
34
Introduction: Control Reference Guide
2 3 4 5
8 10 9 11 12
6
13 14
* 1
For how to open the connector cover, refer to "Opening the eSATA,
USB HOST and USB DEVICE connector cover" (page 17).
4.
TIME CODE IN/OUT connector
This connector inputs and outputs time code signals.
TIME CODE IN:
TIME CODE
OUT:
◆ NOTE:
• When setup menu No.25 (SYSTEM FREQ) is set to 59-23,
60-24 or 60-25, time code signals cannot be input to the
TIME CODE IN connector.
• Use double shielded cable for making connections to TIME
CODE IN/OUT connectors.
5.
REF VIDEO IN connectors
This connector inputs and outputs HD and SD
reference video signals and outputs loop-through
signals.
◆ NOTE:
• It is recommended that this unit be used with a system that
inputs a reference video signal since video and audio
output signals may otherwise deteriorate.
• Input tri-level sync signals with both positive and negative
polarities as HD reference video signals. Input signals that
meet the input signal and data format.
➝ For a reference signal, refer to "Example of Connections
in 23.98/24/29.97/25 Hz Mode" (page 45).
• Input a black burst signal that complies with SMPTE170M
and ITU624-4 to use for SD reference video signals.
• When no cable is connected to the REF VIDEO loop
* 1
Connector cover
7
15 16 17
Use to record an external time
code onto P2 cards.
This terminal outputs the playback
time code during playback.
During recording, it outputs the
time code generated by the time
code generator.