I Rear View - Panasonic WJ-HD220 Operating Instructions Manual

I Rear View

#0
IN
OUT
OUT
AUDIO
#1
#0 Audio Input Connector (AUDIO IN)
An RCA standard jack that accepts an unbalanced
–10 dBV, 10 kΩ line input audio signal supplied from an
external device.
#1 Audio Output Connector (AUDIO OUT)
An RCA standard jack that supplies an unbalanced
–10 dBV, 600 Ω line output audio signal to an external
device.
#2 Video Input Connector (VIDEO IN 1-8)
Connectors 1-4 allow direct connection of the PSD
cameras (video and commands multiplexed) while con-
nectors 5-8 accept only normal video signals. A 75 Ω
termination is made unless the video output terminal is
connected.
#3 Video Output Connector (VIDEO OUT 1-8)
This BNC supplies a video signal looped through the
video input terminal.
Connectors 1-4 will output signals only when the
recorder is turned on.
#4 Spot Output Connector (SPOT OUT)
This BNC supplies a full-screen live image signal to the
spot monitor while recording or not recording. No play-
back or split image, setup menu, or OSD information is
supplied via this connector.
#5 Multiscreen Output Connector (MULTISCREEN OUT)
This BNC provides the multiscreen monitor with the fol-
lowing video.
• Live image: single spot, multi-split spot, single
sequence, quad-split sequence
• Playback image: single spot, multiscreen spot
• OSD information: camera title, time and date,
recorder status, alarm status
The menu setup windows are also provided via this
BNC.
10
#2
IN 8 7 6 5 4
8 7 6 5 4
VIDEO
#3
#4 #6
3 2 1
SPOT
OUT
ALARM/REMOTE
3 2 1
MULTI
RS-232C MODE
SCREEN OUT
#5 #7 #8
#6 Alarm/Remote Port (ALARM/REMOTE)
This port accepts the alarm inputs 1 - 8, and remote
controls while supplying status outputs. See ALARM/
REMOTE Connection for details.
#7 RS232C Port (RS-232C)
This 9-pin port is used to communicate with the person-
al computer when controlling the recorder, or updating
the firmware installed in the recorder. See Serial Port
Connections for cable wiring, and RS-232C Communi-
cation Protocol.
#8 Mode Setup DIP Switch (MODE)
A 6-bit switch is used for such system setups as disk
formatting, PSD chain termination, and so forth. See DIP
Switch Setting for details.
#9 10Base-T/100Base-T (10/100BASE-T)
This port is used to exchange control data with Ethernet
via an Ethernet Hub.
$0 Data Port (DATA)
This port is used to communicate with external devices
compatible with the PSD (Panasonic Security Data) pro-
tocol based on RS485.
$1 Cooling Fan
Prevents the temperature of the recorder from rising. Do
not block the ventilation openings.
$2 Power Switch (POWER ON OFF)
This switch turns the power of the recorder on and off.
$3 Signal Ground Terminal (SIGNAL GND)
$4 Power Cord
Is connected to an AC outlet.
#9 $0 $1 $2 $3
POWER
ON
OFF
10/100BASE-T DATA
SIGNAL GND
$4