Creating Playlists; Registering Events In A Playlist - Panasonic AJ-HPD2500P Operating Instructions Manual

Registering Events in a Playlist

To register an event in a playlist, either set IN and OUT points
using the player and the recorder, or select clips from the
player thumbnails.
Setting IN and OUT points to assign an
event
Defining any three of four points (the IN and OUT points of
both the player and the recorder) automatically defines the
remaining point.
It is also possible to set only the IN points for the player and
the recorder.
◆ NOTE:
• When only the IN points for the player and the recorder are set and
the player is a P2 card or hard disk, the audio and video of the event
from the IN point of the player until the end of the clip where the IN
point is set is inserted at or starts overwriting data from the recorder
IN point.
• When an external device or external input (live recording) is used as
the player, audio and video up to 24 hours (excluding the preview
time) is inserted or starts overwriting data at the IN point of the
recorder.
• When an external input (live recording) is used as the player, IN and
OUT points of the player cannot be registered.
Selecting player
Select a P2 card, hard disk, external device (RS-422A), or
external input (live recording) as a player.
A P2 card is normally used as a player. Follow the steps below
to select other devices or external input (live recording) as a
player or to again select a P2 card as a player.

Creating Playlists

1
2
3
1
3
2
Press the PLAY LIST button to open the playlist
screen.
Press the SOURCE SELECT (SHIFT + PLAYER)
button.
Use the cursor buttons to select an interface for the
player and press the SET button.
This determines the external device (interface) that can be
remotely operated.
➝For details on connecting and setting up external
devices, refer to "Connections" (page 124) and
"External Remote Control" (page 137).
97
Editing: Creating Playlists