Table of Contents
Advertisement
To turn off resume playback, set to [OFF] in step 4.
◆ NOTE:
• A change in setting will not change the resume playback setting
of a P2 card.
Setting up skip mode (SKIP MODE)
Select skip operation (cue up) to be performed during various
playback operations and pause.
1
Press the MENU button.
2
Select [PLAY SETUP] and press the SET button.
3
Select [SKIP MODE] and press the SET button.
4
Select skip operation and press the SET button.
CLIP:
Press NEXT (SHIFT + FF), PREV (SHIFT
+ REW) buttons during a pause to move
to the beginning of the next or previous
clip.
CLIP & INDEX: Press NEXT (SHIFT + FF), PREV (SHIFT
+ REW) buttons during a pause to move
to the beginning of the next or previous
clip or the location of the next or
previous index location.
5
Press the MENU button to return to the thumbnail
screen.
◆ NOTE:
• An index is attached to a certain video point of a clip being
recorded or played back. You can then select only clips with
indexes for display/playback. Note, however, that an index
cannot be attached nor removed by this unit.
Playing Back AVCHD Clips
Playback
Use the steps below to play back clips, which are available
only from thumbnails.
1
Use the cursor buttons to move the cursor to the clip
you want to play.
2
Press the PLAY button.
The clip at the cursor location will now be played.
Press the STOP button to stop playback and return to
thumbnails.
Slow/fast forward/rewind
Use the search dial during playback or pause to select
playback speed.
Press the PLAY button to return to normal playback.
◆ NOTE:
• The audio is played back only at 1x speed.
• During reverse playback, video is played back with gaps every 0.5
sec interval.
• In JOG mode, not like during P2 card playback, a smooth playback
is not possible.
• In SHTL mode, 16x playback speed is available (maximum).
Clip forward/rewind
1
Play back or enter pause mode.
2
Press the PREV (SHIFT + FF)/NEXT (SHIFT + REW)
button.
The unit will now perform set skip operation.
Recording AVCHD Material on P2
Cards
Use the steps below to record AVCHD video to a P2 card in
the DVCPRO HD or AVC-Intra format.
■ Preparing for recording
1
Set recording and playback format.
Set the recording format (1080i/720P) to the same format
as the PB format from setup menu No. 020 (SYS FORMAT)
and set the recording format (DVCPRO HD/AVC-I 100/
AVC-I 50) using setup menu No. 025 (REC FORMAT
(HD)).
Then set the playback format for AVCHD mode.
➝Refer to "Setting playback format (PB FORMAT)" (page
168).
◆ NOTE:
• Dubbing is not available when setting of the setup menu No.020
(SYS FORMAT) differs from PB FORMAT.
2
Insert a P2 card that can be recorded.
Insert a card for dubbing or select a slot to enable
recording.
◆ NOTE:
• Dubbing is not available when loop recording is activated.
AVCHD Recording and Playback: Using an Optional AVCHD Board
169
Advertisement
Table of Contents
