Table of Contents
Advertisement
3
Partitions or holders are selected and
.
4
You can now use the selected partition or folder as a
target for processing.
The selected areas remain available until the hard disk is
disconnected or the power it turned off. To release a
selected partition, press the ENTRY button again in the
selected partition. Use the CANCEL (SHIFT + EXIT) button
to cancel all selected areas.
• A warning appears when an attempt is made to select a 7th
area.
◆ NOTE:
• A clip recording that spans several partitions one of whose
MODEL has become UNKNOWN
not run as a normal clip.
1
*
When a clip is copied to a TYPE S hard disk, the MODEL of
the partition storing the copy changes to UNKNOWN.
Naming a partition
To name a partition (up to 20 characters), choose [CHANGE
PARTITION NAME] in the [OPERATION] menu in hard disk
thumbnail view.
◆ NOTE:
• A TYPE S hard disk makes it possible to set partition names. The
selected partition name appears in "PARTITION NAME" in the
explorer screen.
1
Use the cursor buttons to select a partition or folder
to name. Or press the SET button repeatedly to open
the thumbnail list screen.
2
Press the MENU button and use the cursor buttons
to choose [OPERATION] – [CHANGE PARTITION
NAME] and press the SET button.
3
Enter the name of the partition using the on-screen
keyboard that appears.
132
Connections: Using This Unit With a Hard Disk
changes to
*
1
on a TYPE S hard disk will
4
Press the ENTRY button to confirm the name.
Deleting the last partition
Use the steps below to delete the last partition.
◆ NOTE:
• The last partition can only be deleted on a TYPE S hard disk. This
function can delete only the last partition and not any intermediate
partitions.
• Make sure the partition to be deleted does not contain any data you
need as it will not be possible to recover it after deletion.
1
Move the cursor to the last partition in the hard disk
explorer screen and open the menu.
2
Choose [OPERATION] – [DELETE LAST
PARTITION] and press the SET button.
3
Select [YES] in the confirmation message that
appears.
4
When the partition has been deleted, "COMPLETE"
appears and the last partition disappears from the list
of partitions.
Advertisement
Table of Contents
