Table of Contents
Advertisement
4
REM(G)
7
REM RX(X)REMOTE CONTROL
PROTOCOL RECEIVE
8
REM COMMANDREMOTE CONTROL
PROTOCOL TRANSMIT
14
REM RX(Y)REMOTE CONTROL
PROTOCOL RECEIVE
15
REM TX(Y)REMOTE CONTROL
PROTOCOL TRANSMIT
◆ NOTE:
• The ENCODER REMOTE connector supports digital
signals only.
• Use shielded cable for making connection to ENCODER
REMOTE connector.
11.
RS-232C connector
Use this connector to control this unit from a PC or
other device.
Pin No.
Signal
1
—
2
TXD
3
RXD
4
DSR
5
SG
6
DTR
7
CTS
8
RTS
9
—
◆ NOTE:
• Use double shielded cable for making connection to RS-
232C connector.
12.
REMOTE connector
This unit can be connected to an external controller to
enable remote operation of the unit or connect and
control an external device.
RS-422A REMOTE(9P)
Pin No.
Signal
1
FRAME GROUND
2
TRANSMIT A
3
RECEIVE B
4
RECEIVE COMMON
5
—
6
TRANSMIT COMMON
7
TRANSMIT B
8
RECEIVE A
9
FRAME GROUND
36
Introduction: Control Reference Guide
◆ NOTE:
• Use shielded cable for making connection to REMOTE
connector.
13.
ANALOG AUDIO connectors
Inputs and outputs analog audio signals.
CH1/CH2 IN
Analog audio input connectors.
connector:
A switch permits switching the
input impedance of CH1 and CH2.
CH1/CH2 OUT
Analog audio output connectors.
connector:
Outputs signal selected in setup
menu No.750 (A CH1/2 SEL).
MON L/R
Analog audio output connectors.
connector:
During playback, these
connectors output the audio
signals (CH1, CH2, CH3, CH4,
CH5, CH6, CH7 and CH8) that are
selected with the AUDIO MON SEL
buttons.
14.
SIGNAL GND connector
Connect this connector to the signal ground connector
of connected devices to lower noise.
This is not a safety ground connector.
15.
eSATA connector
Enables connection of a hard disk drive with an eSATA
connector using the unit as host device.
➝Refer to "Using This Unit With a Hard Disk" (page
126).
16.
USB 2.0 HOST connector (Type A)
Connect P2 store and USB 2.0 compliant hard disk
drives for use in the USB host mode.
➝Refer to "Using USB or eSATA Connectors" (page
124).
17.
USB 2.0 DEVICE connector (Type B)
Connect personal computers and other devices for
use in the USB device mode.
➝Refer to "Using USB or eSATA Connectors" (page
124).
◆ NOTE:
• Use double shielded cable for making connections to USB
2.0 connectors.
Advertisement
Table of Contents
