Rear Panel - Panasonic aj-spd850p Operating Instructions Manual

Control reference guide (continued)

Rear Panel (1/2)

AC IN
SIGNAL
GND
AC IN socket
Connect one end of the power cord supplied to this
socket and the other end to the power outlet.
DIGITAL AUDIO IN and OUT connectors
These are the input and output connectors for digital
audio signals that comply with the AES/EBU standards.
Note:
The digital audio signals must be synchronized with
the video input signals; otherwise noise will be
generated in the audio output signals.
ANALOG COMPONENT VIDEO IN connectors
The analog component video signals are input to these
connectors.
ANALOG COMPOSITE VIDEO IN connectors
and 75 Ω termination switch
Input connectors for analog composite video signals.
A loop-through configuration is featured for each pair of
input connectors.
For termination at the memory card recorder, set the
switch to [ON].
REF VIDEO IN connectors and 75 Ω termination
switch
Input connectors for reference video signals.
Input a reference signal with color burst.
For termination at the memory card recorder, set the
switch to [ON].
Note:
Video and audio output may be disturbed when the
reference video signal is not input, so use a system
which inputs the reference video signal.
Remote control connectors
Connect the memory card recorder to an external
controller.
ENCODER REMOTE connector
Connect the memory card recorder to an external
encoder to adjust video output signal settings from an
external component.
AES/EBU ANALOG REMOTO
VIDEO
CH1•2
IN
IN
REMOTO IN
ON
Y
75Ω
CH3•4
IN OFF
P B
REF VIDEO
CH1•2 IN
OUT
ENCODER REMOTE
ON
P R 75Ω
CH3•4
OFF
OUT
RS-232C
Y 1
P B
2
3
P R
(SUPER)
SERVICE ONLY
– 15 –
ANALOG
AUDIO
TC
CH1 CH2
IN
IN
TC
CH3 CH4
OUT
CH1 CH2 MON
AUDIO
L
OUT
CH3 CH4
MON
R
ANALOG AUDIO IN connectors
These are the analog audio input connectors.
TIME CODE IN connector
Use to record an external time code onto the cards.
TIME CODE OUT connector
Outputs the playback time code during playback.
Outputs the time code generated by the internal time
code generator during recording.
SERIAL DIGITAL COMPONENT AUDIO and
VIDEO IN and OUT connectors (optional)
Installing an SDI board (optional board AJ-YA755G) in
the memory card recorder enables input/output of digital
component audio/video signals conforming to the
SMPTE259M-C standard.
Video signals containing superimposed information can
be output through the SDI OUT 3 connector.
To turn the superimposed information ON or OFF, use
the SUPER switch on the front panel.
Note:
The digital audio signals must be synchronized with
the video input signals; otherwise noise will be
generated in the audio output signals.
SDI
IN OUT
1
ACTIVE
THROUGH
2
3
(SUPER)
DVCPRO/
DV
(OPTION)
100BASE-TX