Swift Motorhome Owners Service Manual page 206

Water
Fault Cause
Water flows Cold water pipe kinked
from hot preventing flow
tap but has
Blockage in cold pipe line
reduced flow
from cold
Cold tap not connected
Cold tap failed or blocked
If a water filter is fitted, the
cartridge is exhausted
Reduced flow Battery condition low
from both hot causing pump to
and cold taps run slowly
If new taps have been fitted
they may be restricting flow
Pump needs servicing
Partially blocked pump filter
or in-line filter, if fitted
Pump outlet pipe kinked
restricting flow
Water leak
Reduced flow Y' connector(s) fitted
from either tap incorrectly
Pipe kinking restricting flow
Bore size difference in taps
If pump motor Battery voltage may be
runs steadily too low (below 10.5 volts)
and will not
stop
WAT E R FA U LT S
Remedy
Check and re-route if necessary
Disconnect pipes after 1st Y connector and
check up to tap
Refer to installation instructions
Disconnect and inspect
Replace cartridge
Check battery state of charge,
refer to electrical supply note
Disconnect and check that they have at least
1/4" (6.3mm) bore
Refer to pump servicing instructions
Dismantle and clean if necessary
Check and re-route if necessary
Check all water connections
Refer to installation instructions
Check and re-route if necessary
Use taps of equal bore size
Check that there is water in the container
Adjust switch and/or re-charge battery
Check all connections in pipework
205