Swift Motorhome Owners Service Manual page 121

ALD E H EATIN G
3. From standby mode to setting menu
When on standby, the indoor temperature is
displayed, and the outdoor temperature is
displayed if an outdoor temperature sensor
has been connected. The background lights
up when you press the screen or the MENU
button. Start the setting menu by pressing
the MENU button. The background lights up
and those functions which can be set are
displayed. The settings are automatically saved
after 10 seconds. The control panel reverts to
standby automatically after 30 seconds if no
buttons are pressed (or if the MENU button in
the setting menu is pressed).
1. The control panel in standby.
2. The control panel in setting menu.
+22°C
2 kW
ON
Off
120
+22°C
+6°C
Fri 18.30
On
Note: if "Standby Brightness" is set to Off,
the display goes out when it enters standby
mode, but lights up if you press the screen.
See settings under 9.12.
4. Set the required temperature
The temperature can be set from +5°C to
+30°C in steps of 0.5°C. Warm water is
always available (50°C) when the boiler is on
and running on LPG and/or electricity. During
summer, when only warm water is required,
adjust the temperature setting to well below
the surrounding temperature so that central
heating circulation is not called for.
+22°C
2 kW
ON
Off On
1. The temperature displayed is the
temperature which is set at present
(in this case 22.0°C).
2. Raise the temperature by pressing the +
button. Lower the temperature by pressing
the – button.
3. The settings are ready and the central
heating will circulate at the set temperature.
5. Hot water boost
If you need more warm water, you can raise
the water temperature temporarily from 50°C
to 65°C. After 30 minutes, the boiler reverts
to normal operation. While hot water boost is
activated, the circulation pump is stopped.