Swift Motorhome Owners Service Manual page 161

CO O K ER OP ERATI ON
Shelf positions are from the top down. When
roasting with aluminium foil care must be taken
that the foil does not impair circulation or block
the oven flue outlet.
Gas
Mark
1/4 - 1/2
1
2
3
4
5
6
7
8
9
Do's and don'ts
Do read the user instructions carefully before
using the appliance for the first time.
Do allow the oven to heat before using for the
first time, in order to expel any smells before
the introduction of food.
Do clean the appliance regularly.
Do remove spills as soon as they occur.
Do always use oven gloves when removing
food shelves and trays from the oven.
Do check that controls are in the off position
when finished.
Don't allow children near the cooker when in
use. Turn pan handles away from the front so
that they cannot be caught accidentally.
Don't allow fats or oils to build up in the oven
trays or base.
Don't use abrasive cleaners or powders that
will scratch the surfaces of the appliance.
Don't under any circumstances use the oven
as a space heater.
Don't put heavy objects onto open grill and
oven doors.
160
Temperature
(Centre - Shelf Pos. 2)
265 - 275°F 130-135°C
285 140
300 150
330 165
355 180
385 195
410 210
430 220
445 230
465 240
Leaks
If a smell of gas becomes apparent, the
supply should be turned off at the cylinder
IMMEDIATELY. Extinguish naked lights
including cigarettes and pipes. Do not
operate electrical switches. Open all doors
and windows to disperse any gas escape.
LPG gas is heavier than air; any escaping
gas will therefore collect at a low level. The
strong unpleasant smell of gas will enable
the general area of the leak to be detected.
Check that the gas is not escaping from an
unlighted appliance. Never check for leaks
with a naked flame, leak investigation should
be carried out using a leak detector spray.
Maintenance & servicing
Important
• Shut off gas supply at isolating valve, switch
off electric supply and ensure all parts are
cool before cleaning or servicing
• All servicing must be carried out by an
approved competent person.
• After each service the appliance must be
checked for gas soundness
• This appliance must not be modified or
adjusted unless authorized and carried out
by the manufacturer or his representative.
No parts other than those supplied by
the manufacturer should be used on this
appliance.
• If the supply cord is damaged, it must only
be replaced by the manufacturer or his
representative in order to avoid a hazard.
This appliance needs little maintenance other
than cleaning. All parts should be cleaned
using warm soapy water. Do not use abrasive
cleaners, steel wool or cleansing powders.
When cleaning the burner ring it is essential
to ensure that the holes do not become
blocked. The control knobs are a push fit
and can be removed for cleaning. They are
interchangeable without affecting the sense of
operation.