Ink Cartridge; Replacing With A New Ink Cartridge - MIMAKI JF-1631 Operation Manual

Ink cartridge

Replacing with a new ink cartridge

Replacing of ink cartridges is required in the following cases.
Display on the screen
< L OC A L >
I N K N E A R E ND : M _ _ _ _ _ _
< L OC A L >
I N K E ND : M _ _ _ _ _ _ _
Replacement of ink cartridges
Perform the replacement of the ink cartridges in the local mode or after cutting OFF the power supply
( P.2-15 ).
1
Remove an ink cartridge to be
replaced.
2
Set a new ink cartridge
• As shown in the drawing, set an ink cartridge
turning up a side containing the IC chip.
• Ink fill up starts.
4-4
Remaining amount of ink in an ink cartridge is few.
• Drawing can be continued, but running out of ink may occur during the drawing.
Earlier replacement is recommended.
• The display shown in the left indicates that magenta ink is few.
Ink in an ink cartridge is run out.
• Drawing can not be continued. Replace with new one immediately.
• The display shown in the left indicates that magenta ink is run out.
Outline
IC chip