D Direct Code Entry - Icom IC-F1721 Instruction Manual

D D Direct code entry
q While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
• Code digit for editing blinks.
0 5 0 0
w Push [P3] (TX Code Enter) to select the desired digit to be
edited.
• Digit for editing differs according to the setting.
e Set the desired digit using [CH Up]/[CH Down]/[DIAL] or
10-keypad*.
*IC-F1821/D or IC-F2821/D only
r Push [P3] (TX Code Enter) to set the digit, then the digit
to the right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
t Repeat e and r to input all allowable digits.
y Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
WAIT
and is displayed during each call. However, an
" "
error beep sounds and
answer back is received after the calls.
is displayed when no
"FAILED"
u Push [PTT] to transmit; release to receive.
i Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
For your information
When the "UpDate" setting for the call code is enabled, the
set code is overwritten into the call code memory.
3
BIIS OPERATION
3
17