D Direct Code Entry - Icom IC-F5060 Series Operating Manual

2
BIIS 1200 OPERATION

D Direct code entry

q In the standby mode, push [TX Code Enter] to enter the
TX code edit mode.
• A Code digit blinks.
w Push [TX Code Enter] to select the desired digit to be
edited.
• Editable digits differ according to the transceiver setting.
e Push [CH Up] or [CH Down] to select the desired digit.
r Push [TX Code Enter] to set the digit, then the digit to the
right will automatically blink.
t Repeat e and r to edit all allowable digits.
y Push [Call] or [PTT]* to call.
* A PTT call can be made only when PTT call capability is permit-
ted.
NOTE: When no answer back is received, the trans-
ceiver automatically repeats the call 3 times (default),
and "WAIT" is displayed during each call. However, an
error beep sounds and "FAILED" is displayed when
no answer back is received after the repeated calls.
7
1 2 3 4
u Push [PTT] to transmit; release to receive.
i Push [Moni (Audi)] to send a 'Clear down' signal.
For your information
When the "UpDate" setting for the call code is enabled, the
set code is overwritten into the call code memory.