Datamax I-Class Mark II Operator's Manual page 59

DISPLAYED ITEM
CONTROL
CODES
STANDARD
CODES
ALTERNATE
CODES
ALTERNATE
CODES 2
CUSTOM
CODES
FEEDBACK
CHARACTERS
ENABLED
DISABLED
ESC SEQUENCES
ENABLED
DISABLED
HEAT COMMAND
ENABLED
DISABLED
SPEED
COMMANDS
ENABLED
DISABLED
TOF SENSING
COMMANDS
ENABLED
DISABLED
SYMBOL SET
COMMAND
ENABLED
DISABLED
CNTRL-CODES
(DATA)
ENABLED
DISABLED
STX-V SW
SETTINGS
ENABLED
DISABLED
MAX LENGTH
COMMAND
ENABLED
DISABLED
PROCESS SOH
(DATA)
ENABLED
DISABLED
Chapter 4 – Menu System
Allows changes to the prefix of the software commands interpreted by the printer,
where:
Use these characters: Hex 01 = SOH command; Hex 02 = STX command; count-
by = ^; Hex 1B = ESC; Hex 0x0D = Carriage Return. (Default Setting)
Use these characters: Hex 5E = SOH command; Hex 7E = STX command; count-
by = @; Hex 1B = ESC; Hex 0x0D = Carriage Return.
Use these characters: Hex 5E = SOH command; Hex 7E = STX command; count-
by = @; Hex 1B = ESC; Hex 0x7C = Carriage Return.
Each DPL command (SOH, STX, CR, and count-by) may be selected by entering
the desired Hex code.
Allows the printer to return a Hex 1E (RS) after each label successfully prints, and
a Hex 1F (US) after each label batch successfully prints, where:
Sends feedback characters to the host.
Does not send feedback characters to the host. (Default Setting)
Allows data containing invalid ESC control code sequences to be processed, where:
Processes commands normally. (Default Setting)
Ignores ESC sequences are during processing (since some systems send a
"banner" to the printer). Bitmapped font downloads are disabled in this mode.
Determines the way the DPL Heat command is handled, where:
Processes commands normally. (Default Setting)
Ignores DPL Heat commands; instead, the heat value is controlled via the menu
setting.
Determines the way DPL Print, Feed, Slew, and Reverse commands are handled,
where:
Processes commands normally. (Default Setting)
Ignores DPL speed commands; instead, the speeds are controlled via the menu
setting.
Determines the way in which DPL Gap, Continuous, and Reflective commands are
handled, where:
Processes commands normally. (Default Setting)
Ignores DPL TOF commands; instead, TOF is controlled via the menu setting.
Determines the way in which DPL Single and Double Symbol Set commands are
handled, where:
Processes commands normally. (Default Setting)
Ignores DPL Symbol Set commands; instead, the Symbol Set selection is controlled
via the menu setting.
Determines the way in which DPL SOH, STX, CR, ESC, and ^ codes are handled,
where:
Processes commands normally. (Default Setting)
Ignores DPL Control Codes; instead, the control code functions are established via
the menu setting.
Determines the way in which the DPL <STX>V command is handled, where:
Processes commands normally. (Default Setting)
Ignores the option-enable command; instead, the option selections are controlled
via menu settings.
Determines the way in which the DPL <STX>M command is handled, where:
Processes commands normally. (Default Setting)
Ignores the maximum label length command; instead, Maximum Label Length is
controlled via the menu setting.
Determines the way the printer responds to an Immediate Command (e.g., Get
Status, Module Storage, etc.), where:
Operations are interrupted upon receipt to process the command.
Processes commands normally. (Default Setting)
ITEM DESCRIPTION
53