Datamax I-Class Mark II Operator's Manual page 47

DISPLAYED ITEM
CUTTER
MODE
AUTO
ENABLED
DISABLED
CUT BEHIND
(0 – 2)
0
GPIO PORT
GPIO DEVICE
DISABLED
APPLICATOR
APPLICATOR2
BARCODE
VERIFIER
START OF PRINT
LOW PULSE
HIGH PULSE
ACTIVE LOW
ACTIVE HIGH
EDGE
END OF PRINT
LOW PULSE
HIGH PULSE
ACTIVE LOW
ACTIVE HIGH
Chapter 4 – Menu System
Controls the Cutter operation, where:
Sets the detection method and response of the printer:
Is the default setting, where the presence of the cutter option is automatically
sensed. If detected, the cutter is enabled; otherwise, it will be ignored.
Enables the cutter. If the cutter is not detected, a fault will be generated.
Disables the cutter.
Allows a queue of small labels to accumulate before cutting is performed to
increase throughput.
(1) This mode can be used without a cutter to allow the presentation of
an extra label with retraction upon the next job or feed operation.

(2) After a fault or unknown label position, the leading edge will be cut
to ensure no extra material exists at the beginning of the first label;
otherwise, the cutter will only cut when necessary.
Zero, one, or two are the number of labels to queue before cutting; and
Is the default setting.
Controls the optional Applicator Interface Card's GPIO function, where:
Sets the option to work with a specific device type, where:
Disables the option.
Enables parameters for related label applicator functions:
• Completion upon last SOP, de-asserts Data Ready (DRDY);
• FEED allowed at any time; and,
• DRDY upon PAUSE.
Enables parameters for alternate label applicator functions:
•
Completion upon 1 msec. overlap of Data Ready (DRDY) and End of Print (EOP);
• DRDY signal end inhibits FEED; and,
• De-asserts DRDY upon PAUSE or FAULT.
Enables the GPIO Port to work with a bar code verifier.
Selects the type of input signal required to initiate Start of Print (SOP), where:
Triggers printing with a low pulse.
Triggers printing with a high pulse.
Triggers printing with a low signal.
Triggers printing with a high signal.
Triggers printing with a signal edge transition.
Sets the type of output signal generated to indicate End of Print (EOP), where:
Outputs a low pulse upon completion.
Outputs a high pulse upon completion.
Outputs a logic low upon completion.
Outputs a logic high upon completion.
ITEM DESCRIPTION
41