Datamax I-Class Mark II Operator's Manual page 58

DISPLAYED ITEM
TCP PRINT
PORT
INACTIVITY
TIME
LPD PRINT
PORT
WIRELESS
ETHERNET
IP
DISCOVERY
USE STATIC
ADDRESSES
USE DHCP
USE BOOTP
IP ADDRESS
SUBNET
MASK
DEFAULT
GATEWAY
HOST SETTINGS
HOST TIMEOUT
10
Chapter 4 – Menu System
Selects the Port to use for all TCP network communications; Default is 9100
Set the amount of time (in seconds) in which the current port will remain open
when no activity is present.
Selects the Port to use for all LPD network communications; Default is 515
Controls the communications settings for the wireless Ethernet network interface,
where:
Sets the address discovery method, where:
The stored static IP, Subnet Mask, and / or Gateway Address will be used.
The card broadcasts over the network using DHCP protocol to receive addresses
from the responsible server at startup. Manual modifications to IP Address, Subnet
Mask, or Gateway Address are not allowed; and, if no server is found, the specified
static value will be used. (Default Setting)

A server assigned IP address takes precedence over any static IP
address stored in the interface.
The card broadcasts over the network using BOOTP protocol to receive addresses
from the responsible server at startup. Manual modifications to IP Address, Subnet
Mask, or Gateway Address are not allowed; and, if no server is found, the specified
static value will be used. (Default Setting)

A server assigned IP address takes precedence over any static IP
address stored in the interface.
Specifies the static IP Address of the interface in the standard octet format.
Specifies the static Subnet assigned to the interface, for
example:255.255.255.000.
Specifies the Gateway Address the interface will use, for example:192.168.10.1
Controls the communications with a host device, where:
The "ignore host" settings for ESC SEQUENCES, HEAT, SPEED,

TOF SENSING, SYMBOL SET, CNTRL-CODES, STX-V SW
SETTINGS, and MAX LENGTH will be unaffected when PL-Z Mode
is selected (see Input Mode for details).
Sets the number of seconds (1 - 60) that an established communications port must
be idle before data can be received through an alternate port, where:

If the time-out period is exceeded before all data is received, the
data will be ignored.
Is the Default Setting.
ITEM DESCRIPTION
52