Yealink SIP T46G Administrator's Manual page 34

3. Enter the username and password in the corresponding fields.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after reboot.
5. Click OK to reboot the IP phone.
To configure PPPoE via phone user interface:
1. Press Menu->Advanced (password: admin) ->Network->WAN Port->IPv4.
2. Press or , or the Switch soft key to select the PPPoE from the Type field.
3. Enter the username and password in the corresponding fields.
4. Press the Save soft key to accept the change.
The IP phone reboots automatically to make the settings effective after a period of
time.
There are two Ethernet ports on the rear of the IP phones: Internet port and PC port. You
can configure the transmission method for each port to use to communicate over
Ethernet. The IP phones support the following transmission methods:
Auto-negotiation

Half-duplex

Full-duplex

By default, the IP phones are configured to perform auto-negotiation on both Internet
port and PC port.
Auto-negotiation
Auto-negotiation transmission means that all connected devices choose common
Getting Started
21