Sending Rtp Stream - Yealink SIP T46G Administrator's Manual

Administrator's Guide for SIP-T46G IP Phone
Local
To configure a multicast paging key via web user interface:
1. Click on DSSKey->Line Key.
2. In the desired DSS key field, select Paging from the pull-down list of Type.
3. Enter the multicast IP address and port number in the Value field.
The valid multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
4. Click Confirm to accept the change.
To configure a codec for multicast paging via web user interface:
1. Click on Features ->General Information.
136
Web User Interface
Phone User Interface
362.
Specifies a multicast codec for
the IP phone to use for multicast
RTP .
For more information, refer to
Sending RTP Stream on page 307.
Assign a multicast paging key.
Navigate to:
http://<phoneIPAddress>/servlet
?p=dsskey&model=1&q=load&li
nepage=1
Specifies a multicast codec for
the IP phone to use to send the
RTP stream.
Navigate to:
http://<phoneIPAddress>/servlet
?p=features-general&q=load
Assign a multicast paging key.