Ipx Service Features - HP J3100B Installation And Configuration Manual

IPX Service Features

Enables the switch to be managed in an IPX network. The Switch 2000
automatically enables IPX, configures the IPX node address, and learns the
IPX network number. Thus, in the factory default configuration, IPX is auto-
matically enabled for the switch.
N o t e
In this case, the factory-assigned node address is displayed as shown below.
(The switch automatically detects the IPX network number.)
Figure 3-6. The IPX Service Configuration Screen
N o t e
If VLANs are configured, the above parameters appear in a horizontally
formatted screen.
You can also configure an IPX gateway frame encapsulation type and gateway
node so that the switch can be managed from a remote IPX network.
If VLANs are configured, the switch can automatically learn the IPX network
number of each attached VLAN. For more on VLANs, refer to chapter 7,
"Advanced Concepts".
Configuring the Switch
Configurable Features
Read-Only Field
Appears if Gateway
Encap Configured
3-7