HP J3100B Installation And Configuration Manual page 25

Installing the Switch
4. Mount the Switch
Table Mounting
Place the switch on a table or other horizontal surface. (No special tools are
necessary.) Attach the self-adhesive feet (included in the accessory kit) to the
recessed areas on the bottom front area of the switch. Be certain to pick a
sturdy table in an uncluttered area. You may want to secure the switch's cables
to the leg of the table to help prevent people from tripping over them.
C a u t i o n
Make sure the air flow around the sides and back of the switch is not restricted.
Also, if an HP J3136A AdvanceStack Switch 2000 Redundant Power Supply is
installed, make sure the air flow around the fan area of the RPS is not
restricted.
Route the power cord(s) and data cables so that they will not create a tripping
hazard for people walking in the area of the switch installation.
1-11