HP J3100B Installation And Configuration Manual page 65

Figure 3-14. Example of Selecting a Monitoring Port
5. Press the Space bar to select which port to use for the monitoring port,
then press [v] to move to the Monitor parameter. (The default setting
is Ports, which you will use if you want to monitor one or more individual
ports on the switch.)
6. Do one of the following:
• If you want to monitor individual ports, leave the Monitor param-
eter set to Ports and press [v] to move the cursor to the Action
column for the individual ports. Press the Space bar to select Mon-
itor for each port that you want monitored. (Use [v] to move from
one port to the next in the Action column.) When you are finished,
press [Enter], then press [S] (for Save) to save your changes and exit
from the screen.
• If, instead of individual ports, you want to monitor all of the ports in
a VLAN, press the Space bar to select VLAN in the Monitor parame-
ter, then press [v] to move to the VLAN parameter (figure 3-15). Then
press the Space bar again to select the VLAN that you want to monitor.
When you are finished, press [Enter] , then press [S] (for Save) to save
your changes and exit from the screen.
7. Return to the Main Menu.
Configuring the Switch
Configurable Features
Move the Cursor to
the Monitoring Port
Parameter
Note:
Ports listed in this
screen depend on the
modules currently
installed in the switch.
3-21