HP J3100B Installation And Configuration Manual page 30

Installing the Switch
6. Connect a Console Device (Optional)
4.
Remote Console Management Using a Modem and a Terminal
or PC Terminal Emulator
N o t e
For remote, console management, use a full-duplex, asynchronous (character-
mode) modem.
1.
2.
1-16
Figure 1-10. The Main Menu
If you want to continue with direct console management at this time, refer
to chapter 2, "Using the Console Interface".
At the Switch 2000 site:
a. Connect the modem to the Switch 2000's console port using an
RS-232-C modem cable. (For pin-outs and recommended cables refer
to appendix A, "Cables and Connectors".)
b. If necessary, configure the modem to operate with the current con-
figuration of the Switch 2000. (The modem's default configuration
may be sufficient.)
At the remote site, connect the terminal (or PC emulating a terminal) to
the remote modem using a modem cable. Make sure the terminal and
modems are functioning properly, then establish the link between the
terminal's modem and the Switch 2000's modem according to the modem
instructions.