Port Features - HP J3100B Installation And Configuration Manual

Configuring the Switch
Configurable Features

Port Features

Configures the operating state for each port and optionally assigns selected
ports to a port trunk. (For more on port trunking, refer to chapter 7.) Also
optionally enables you to restrict the amount of broadcast traffic on the port.
The read-only fields in this screen display the port names and port types.
Figure 3-5. Example of the Port Configuration Screen with 100VG and Ethernet
Port names are assigned by slot letter and port number. For example, if an HP
J3102A AdvanceStack Switch Ethernet Module is installed in slot B, then the
four ports in this module are identified as ports B1, B2, B3, and B4. Similarly,
if an HP J3103A AdvanceStack Switch 100VG Module is installed in slot A, then
the two ports in this module are identified as ports A1 and A2.
N o t e
Broadcast limit (the Bcast Limit parameter) can be set for all ports in the
switch (or VLAN, if VLANs are configured) from the Automatic Broadcast
Control (ABC) screen (page 7-30 and following) if ABC is enabled. Setting the
broadcast limit (Bcast Limit) in the above screen is on a per-port basis and
overrides any settings done in Automatic Broadcast Control.
3-6
Read-Only Fields
Modules Installed in the Switch