Download Print this page

Via Direct Usb - Casio DT-X11M10E Quick Start Manual

Dt-x11 series
Hide thumbs


Table of Contents

5.2.2 Via Direct USB

The DT-X11 has a mini USB connector on its left hand side. You can use this to directly connect the
DT-X11 to your PC using a mini USB A-B cable.
Install ActiveSync to Your PC
If you have already installed ActiveSync 3.8, you may skip this step. For installing
ActiveSync, refer to Install ActiveSync to Your PC in Chapter 5.2.1 "Via Direct IrDA".
Install USB Driver to Your PC
Connect a mini-USB cable to the port on the DT-X11, and connect the other end of the cable to
a USB port on your PC. When the DT-X11 is connected for the first time, a dialog appears to
prompt you to install the suitable driver.
Download the USB driver "wceusbsh.inf" and "wceusbsh.sys" at the CASIO website and copy
them to appropriate folder in your PC.
Choose No, not this time and then click Next > button (see Figure 5.9).
Figure 5.9
Choose Install from a list or specific location [Advanced] and then click Next > button
(see Figure 5.10).
Figure 5.10


Table of Contents

  Related Manuals for Casio DT-X11M10E