Setting The Programme - Secure SCS317 User Instructions

Setting the PROGRAMME

Six time and temperature settings are available in each 24 hour period.
Pressing BACK at any time in this process will return you to normal
operating mode.
Press ENTER three
times
Press '-' or '+' to
select time /
temperature period
you wish to set (P1
to P6)
Press ENTER
Press '-' or '+' to
adjust the minutes
then press ENTER.
If you require to set further periods for
the same day, the next period will now
automatically flash. Follow this process
again to programme as required
If only two different temperature settings are required in 24 hours then set
the first time and temperature using programme one (P1) and the second
time and temperature setting using programme setting two (P2). The
remaining programmes (P3 to P6) should all be set to the same time and
temperature as P2.
This same method can be used if three, four or five temperature levels are
required, always using the first settings to provide the temperature change
commands with the remaining settings that are not required set to the same
time and temperature as the last required setting.
The day of the week
will flash
Time / Temperature
setting P1 will flash
Temperature will
flash, use the '-' or
'+' to select the
required
temperature
Press '-' or '+' to
adjust the hours
then press ENTER.
The minutes will
then flash.
On completion of period 6
(P6) go to the copy
process on Page 9 of this
booklet
Press '-' or '+'
to select day to
programme
Press ENTER
Press ENTER
The hours START
time will flash
8