Installing The Crank Arms - Shimano FC-MT500-2 Manual

INSTALLATION

Installing the crank arms

„ Installing the crank arms
1
(A)
2
(B)
(B)
3
(A)
To be continued on next page
Fully insert the right crank arm unit
until it touches the bottom bracket.
Set the wide groove area of the left
crank arm into the axle of the right
crank arm unit where the groove is wide.
(C)
Use the SHIMANO original tool to
tighten the cap.
(C)
16
(A)
Wide groove area (left crank arm)
(B)
Wide groove area (axle)
(C)
Apply grease
Premium Grease (Y04110000)
(A)
TL-FC16
(B)
Cap
(C)
Apply grease
Premium Grease (Y04110000)
Tightening torque
0.7 - 1.5 N·m