Quad-Port Stu-C Line Card Overview - Cisco 6260 Installation Manual

Chapter 1 Product Overview
Table 1-5
LED
CAP
DMT
G.LITE
A1
A2
A3
A4

1.2.3.4 Quad-Port STU-C Line Card Overview

The quad-port STU-C line card (4xSDSL)
•
•
•
•
The negotiated bit rate is the lower of the following rates:
•
•
The chassis can include up to 30 4xSDSLs for a total of 120 SDSL modem connections.
Note For hardware specifications for the 4xSDSL line card, see the
page
OL-2365-02
4xflexi LED Indicators (continued)
State
Green solid
Off
Green solid
Off
Green solid
Off
Green solid
Green blinking
Off
Green solid
Green blinking
Off
Green solid
Green blinking
Off
Green solid
Green blinking
Off
Supports 2B1Q line encoding
Is designed for use in a Cisco 6260 system without a POTS splitter configuration
Supports four SDSL modem connections
Converts SDSL modulation from the line into digital data streams to and from the NI-2 card
The provisioned bit rate set for the 4xSDSL in the management software
The assigned bit rate at the CPE
A-5.
Function
The line card is in CAP mode.
CAP mode is not available on the
Note
4xflexi in a Cisco 6260.
The line card is not in CAP mode.
The line card is in DMT mode.
The line card is not in DMT mode.
The line card is in G.lite mode.
G.lite mode is not available on the
Note
4xflexi in a Cisco 6260.
The line card is not in G.lite mode.
Modem 1 is trained.
Training is in progress for modem 1.
Modem 1 is idle.
Modem 2 is trained.
Training is in progress for modem 2.
Modem 2 is idle.
Modem 3 is trained.
Training is in progress for modem 3.
Modem 3 is idle.
Modem 4 is trained.
Training is in progress for modem 4.
Modem 4 is idle.
"Quad-Port STU-C Line Card" section on
Cisco 6260 Hardware Installation Guide
Cisco 6260 System Overview
1-19