Table of Contents
Advertisement
Installation Procedures
4.2.2 Attach Ear Brackets to the Cisco 6260
Verify that the ear brackets on the sides of the chassis are in the proper configuration to fit the rack, and if
necessary, reinstall them. Ear brackets can be installed in two ways, as shown in
Figure 4-1
STATUS
ACTIVE
ATU-C 1
ATU-C 2
ATU-C 3
ATU-C 4
ATUC-1
-4DMT
STATUS
ACTIVE
ATU-C 1
ATU-C 2
ATU-C 3
ATU-C 4
ATUC-1
-4DMT
Bracket orientation for
ETS 600-mm rack
For Cisco 6260 installation in an ETSI 600-mm (23- inch) rack, attach the L-shaped ear brackets so that
the short sides are against the chassis wall and the long sides protrude from the chassis.
For Cisco 6260 installation in a 19-inch rack, attach the ear brackets so that the long side of each L is
against the chassis wall and the short side protrudes from the chassis.
Note
The ear brackets are installed in the factory for a 19-inch rack configuration.
Cisco 6260 Hardware Installation Guide
4-4
Mounting Options for Ear Brackets
PEM 1/PEM 2
AUD_CRIT/AU D_MAJ
AUD_MIN/VIS _CRIT
60V
VIS_MAJ/VIS_ MIN
1 A MAX
STAT_ALARM S
BUS_A/BITS_ B
STATUS
STATUS
ACTIVE
ACTIVE
ATU-C 1
ATU-C 1
ATU-C 2
ATU-C 2
ATU-C 3
ATU-C 3
ATU-C 4
ATU-C 4
ATUC-1
ATUC-1
-4DMT
-4DMT
STATUS
STATUS
ACTIVE
ACTIVE
ATU-C 1
ATU-C 1
ATU-C 2
ATU-C 2
ATU-C 3
ATU-C 3
ATU-C 4
ATU-C 4
ATUC-1
ATUC-1
-4DMT
-4DMT
Chapter 4
Installing a Cisco 6260 Without a POTS Splitter Configuration
PEM 1/PEM 2
AUD_CRIT/AU D_MAJ
AUD_MIN/VIS _CRIT
60V
1 A MAX
VIS_MAJ/VIS_ MIN
STAT_ALARM S
BUS_A/BITS_ B
STATUS
STATUS
STATUS
ACTIVE
ACTIVE
ACTIVE
ATU-C 1
ATU-C 1
ATU-C 1
ATU-C 2
ATU-C 2
ATU-C 2
ATU-C 3
ATU-C 3
ATU-C 3
ATU-C 4
ATU-C 4
ATU-C 4
ATUC-1
ATUC-1
-4DMT
ATUC-1
-4DMT
-4DMT
STATUS
STATUS
STATUS
ACTIVE
ACTIVE
ACTIVE
ATU-C 1
ATU-C 1
ATU-C 1
ATU-C 2
ATU-C 2
ATU-C 2
ATU-C 3
ATU-C 3
ATU-C 3
ATU-C 4
ATU-C 4
ATU-C 4
ATUC-1
ATUC-1
ATUC-1
-4DMT
-4DMT
-4DMT
Bracket orientation
for 19-inch rack
Figure
4-1:
OL-2365-02
Advertisement
Table of Contents
