Table of Contents
Advertisement
Chapter 4
Installing a Cisco 6260 Without a POTS Splitter Configuration
Installation Procedures
interface ATM26/3
no ip address
!
end
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
Note
To configure your system, refer to the appropriate software or network management
configuration guides.
Cisco 6260 Hardware Installation Guide
4-27
OL-2365-02
Advertisement
Table of Contents
