Displaying The Battery Voltage Level And System Status; 1 ] Displaying The Battery Voltage Level; 2 ] Displaying The System Status - Denso BHT-8000 User Manual

2.3.4 Displaying the Battery Voltage Level and System Status

[ 1 ] Displaying the Battery Voltage Level

On the SYSTEM MENU or during execution of user programs, pressing the ENT key while holding down
the SF key will display the battery voltage level.
As long as you hold down those keys, the following screen is displayed.
• If the BHT is placed in the alphanumeric entry system in user programs, the combination of the SF
and ENT keys cannot be used for displaying the battery voltage level. This is because in the
alphanumeric entry system the SF key is used for switching between the numeric and alphabet entry
modes as described in [ 2 ] below.
• In user programs, you may select the key to be used for displaying the battery voltage level (instead
of the default: combination of SF and ENT keys).
• The displayed battery level shows the terminal voltage of the battery, not how much power is left.
The actual voltage level varies depending upon the operation of the BHT, so the displayed level also
may vary.

[ 2 ] Displaying the System Status

The BHT can display the system status--shift state of the keys, alphabet entry mode and
communications link with the CU-8011 on the bottom line of the LCD, using the icons shown below. For
those icons, refer to the next page.
You may select whether or not to display the system status in SYSTEM MENU (refer to Section
2.5.3, [4.2]) or in user programs. The default is to display the system status.
Chapter 2 Getting Started the BHT and System Mode
Shift state of the keys
Alphabet entry mode
Communications link with the CU-8011
27