Denso BHT-8000 User Manual page 76

Setting the communications parameters for the IrDA interface
(1) Communications parameters setting screen
(2) Communications protocol option screen
Selecting "1:OPTICAL" on the SET COMMUNICATION menu calls
up the screen shown at left.
[1] PARAMETER:
[2] PROTOCOL:
Select a desired screen by using the numerical keys or F5 and F6
keys, and then press the ENT key.
To return to the SET COMMUNICATION menu, press the C key.
Selecting "1:PARAMETER" on the SET OPTICAL screen calls up the
screen shown at left.
Highlighted is the current setting.
Select the desired transmission speed by using the numerical keys or
F7 and F8 keys, and then press the ENT key.
To return to the SET OPTICAL screen, press the C key.
Selecting "2: PROTOCOL" on the SET OPTICAL screen calls up the
screen shown at left.
Highlighted is the current setting.
[1] SERIAL No.:
[2] H. PARITY:
[3] LINKUP TIME:
[4] FIELD SPACE:
Select a desired item by using the numerical keys or F5 and F6 keys.
Then select a desired setting by using the F7 and F8 keys.
To return to the SET OPTICAL screen, press the C key.
If the BHT-Ir protocol has been selected, the serial number and
horizontal parity settings will be ignored.
63
Chapter 2 Getting Started the BHT and System Mode
Switches to
parameters setting screen.
Switches to the communications protocol
option screen.
Selects whether or not to add serial numbers
to data blocks.
Selects whether or not to add a horizontal
parity.
Selects the timeout length (in seconds) to be
applied when a link is to be established.
Specifies the treatment of trailing spaces in
fields.
To trim trailing spaces in fields, select Ignore;
to retain them as data, select Data.
the communications