Communicating With The Host Pc; Setting The Transmission Speed Of The Cu-8000 - Denso BHT-8000 User Manual

5.4 Communicating with the Host PC

5.4.1 Setting the Transmission Speed of the CU-8000

CU-8001/8002: Set the transmission speed to the same value as that of the BHT and host PC, by
using the DIP switch.
CU-8021: The transmission speed is automatically determined by the host PC.
CU-8011: Use the CU with the transmission speed fixed to 115,200 bps (default). (Do not disturb
the DIP switch.)
The DIP switch is located next to the RS-232C interface connector on the side of the CU-8001/8002.
(1) Remove the protection sheet from the CU-8001/8002.
(2) Set the selectors of the DIP switch as shown below.
(3) Reinstall the protection sheet.
Do not set the DIP switch to any configurations other than one of the five shown above.
When removing the protection sheet, take care not to let any foreign material get into the CU.
156