Lifescan SureStepFlexx Operator's Manual page 67

IMPORTANT:
test strip after the linearity solution is applied. If
you insert the test strip after 2 minutes, you may get
an out-of-range result or an error message. Discard
the test strip and repeat the test with a new test strip.
The test result appears in
approximately 30 seconds.
The time may vary depending
on the temperature and glucose
level.
IMPORTANT:
the test strip until the
countdown is complete.
NOTE:
The meter can display linearity results up to
766 mg/dL.
10
Press
Linearity Level screen. Press
Run REP 2
the remaining replicates of
level 1.
Or, if you wish to record
additional information with the
test result, press
choose 1 to 3 comments from the list. Press
NOTE:
Results tagged with the comment "Procedure
Err" are not included in the statistical calculations
for any linearity tests.
11
When you complete all replicates for level 1,
Next Level
press
to proceed with the remaining linearity solution
levels (2 through 5).
You have up to 2 minutes to insert the
Do not remove
to display the
to proceed with
Entr Note
from the Linearity Level screen
Chapter 5: Special Tests
L i n e a r i t y 1 R e s u l t
45
L i n e a r i t y 1 L e v e l
R u n
R E P 2
Next Level
and
mg/dL
Entr
Note
.
55