Philips Sopho 2000 IPS User Manual page 648

Built-in SMDR Service Programming
To provide an SMDR service, do the following programming in addition to the programming for the Built-
in SMDR on RS-232C or Built-in SMDR on IP.
START
CM08 Assign the Pseudo-Answer signal function
when the answer signal (Battery Reversal) has
not been detected within the time assigned by
CM41 Y=0>03 after making an outgoing trunk
call.
NOTE:
CM13 Provide the SMDR service for outgoing calls
to the required stations.
CM35 Specify the type of answer signal from distant
office in outgoing connection for each trunk
route.
Provide the SMDR service for outgoing calls
to the required trunk routes.
Assign a trunk access code sent to SMDR for
outgoing calls.
CM41 Specify the timing of SMDR valid call timer
(pseudo-answer timer).
A
DESCRIPTION
This data is effective when CM35
Y=04 is set to "1".
STATION MESSAGE DETAIL RECORDING (SMDR)
(1) 123
(2) 0 : Not sent
1 : To send
• Y=06
(1) X-XXXXXXXX: Station No.
(2) 1 : To provide
• Y=04
(1) 00-63: Trunk Route No.
(2) 1 : Battery Reversal from C.O. line
2 : Answer signal arrives from Tie line/
ISDN
7 : Answer signal does not arrive
• Y=14
(1) 00-63: Trunk Route No.
(2) 1 : To provide
•
Y=44
(1)
00-63: Trunk Route No.
(2)
00-99: Trunk access code
• Y=0
(1) 03: Pseudo-answer timer
(2) 00-08: 8-40 seconds
If no data is set, the default data is 20-24 sec-
onds.
– 630 –
PROGRAMMING
DATA
(4 second increments)
NWA-008845-001 Rev.5.0
32ch1010.fm
JULY/01/2006