My Line Number Display - Philips Sopho 2000 IPS User Manual

MY LINE NUMBER DISPLAY

[Series 3400 software required]
PROGRAMMING
START
CM12 Assign Service Restriction Class A to each sta-
tion.
CM15 Allow the My Line number display in the Ser-
vice Restriction Class A assigned by CM12
Y=02.
CM08 Specify whether Calling number will be dis-
played when a calling station abandons a call
before the call is answered.
CM12 After the above data setting is completed,
allow the system to request the My Line num-
ber information of D
Y=29.
The My Line number information is sent to a
term
D control section of the system according
to CM15 Y=210 data setting.
When sending the My Line number informa-
tion is completed, 2nd data of CM15 Y=210
returns to 1 from 0.
NOTE 1:
NOTE 2:
NOTE 3:
END
HARDWARE REQUIRED
term
D and DLC card
DESCRIPTION
term
station by CM12
When you change CM15 Y=210 data under On-line mode (without CM12 Y=29 data set-
ting), you need to wait several hours until the My Line number display is activated.
To activate the My Line number display immediately after setting CM15 Y=210 under On-
line mode, set 2nd data of CM12 Y=29 to 1(Request a D
number).
The My Line number display is activated immediately after plugging or unplugging D
cable or resetting the system.
PROPRIETARY MULTILINE TERMINAL
• Y=02
(1) X-XXXXXXXX: Station No.
(2) XX ZZ
XX: 00-15 : Service Restriction Class A
• Y=210
(1) 00-15: Service Restriction Class A
(2) 0: Available
(1) 311
(2) 0 : Not available
1 : Available
• Y=29
(1) X-XXXXXXXX: Station No.
(2) 0 : Allow
1 : Not allowed
– 580 –
MY LINE NUMBER DISPLAY
DATA
term
station to send the My Line
NWA-008845-001 Rev.5.0
JULY/01/2006
term
32ch1009.fm