Philips Sopho 2000 IPS User Manual page 223

For non-DID on ISDN, Caller ID incoming calls:
(See SAMPLE DATA PROGRAMMING
NOTE 1: When a Called Party Subaddress is received from ISDN subscriber, CID Call Routing is not
effective.
NOTE 2: When you activate CID Call Routing for Caller ID trunk, do not assign CMDB Y=01, Y=02.
START
CM35
Provide the calling number development and
specify its Development Pattern for each trunk
route number.
NOTE:
CM2A Assign the Development Block number for
each calling party number.
CM65 Select the two kinds of mode change or the
four kinds of mode change per each tenant.
CM76 Assign the station tenant for each calling party
number.
A
2.
DESCRIPTION
For DID on ISDN, T1-ANI, MFC
calls, this data is not effective and
the data setting of CM76 Y=26 is
effective.
Page 209)
• Y=174
(1) 00-63: Trunk Route No.
(2) 0: To provide
(Using Development Pattern 0)
1: To provide
(Using Development Pattern 1)
2: To provide
(Using Development Pattern 2)
• Y=50 Development Pattern 0 assigned by
CM35 Y=174
• Y=51 Development Pattern 1 assigned by
CM35 Y=174
• Y=52 Development Pattern 2 assigned by
CM35 Y=174
(1) X-XX....XX: Calling Party No.
(2) 000-999: Development Block No.
• Y=29
(1) 00-63: Tenant No.
(2) 0 : Two kinds of mode (Day Mode, Night
Mode)
1 : Four kinds of mode (Day Mode, Night
Mode, Mode A, Mode B)
• Y=09
(1) 000-999: Development Block No. assigned
(2) 00-63: Station Tenant No.
– 205 –
CID CALL ROUTING
DATA
(Maximum 16 digits)
X: 0-9
by CM2A Y=50/51/52
NWA-008845-001 Rev.5.0
32ch1004.fm