Philips Sopho 2000 IPS User Manual page 54

A
CM49 Assign the function for each Digital An-
nouncement Trunk card.
CM20 To record, replay and delete a message, assign
the respective Digital Announcement Trunk
access code.
END
NOTE: Announcement Service can be used to provide a voice message when an incoming C.O. line/Tie
line call has been transferred and encounters a busy or no answer condition. After the voice
message is given, normal call processing continues.
• This application can be programmed on a tenant basis.
• Only one (1) message of up to the following seconds can be recorded on an individual Digital
Announcement Trunk Circuit.
Built-in DAT on MP: 120 seconds
4DAT card: 120 seconds
• In this application, a minimum of two digital announcement Trunk Circuits is needed, one for
busy condition, and one for no answer.
• More than one Digital Announcement Trunk Circuit can be used, depending on traffic con-
ditions.
• System programming can be set to, wait until circuits become free or immediately follow pre-
programmed normal call handling, if a busy condition is encountered.
• Digital Announcement Trunk Circuits can be shared among tenants.
• This feature does not function on Attendant transferred calls.
DESCRIPTION
• Y=00
(1) 000-001: Built-in DAT on MP card
002-127: Digital Announcement Trunk No.
(2) 06XX: No Answer
XX : 00-63: Message No.
07XX: Busy
XX : 00-63: Message No.
• Y=06 No Answer
• Y=07 Busy
(1) XX: 00-63: Tenant No. of transferring
(2) XX: 00-63: Message No. assigned by
• Y=0-3 Number Plan Group 0-3
(1) X-XXXX: Access Code
(2) A100: Record
A101: Replay
A102: Delete
– 36 –
ANNOUNCEMENT SERVICE
DATA
(EB002-EB127)
station
CM49 Y=00
NWA-008845-001 Rev.5.0
JULY/01/2006
32ch1001.fm