Motion Events Timeline; Figure 5-8 Detail Of Selection In The Density Chart Of A Report - Honeywell Rapid Eye Operator's Manual

Motion Events Timeline

Document 800-02951V3 Rev A
11/09
Example
To obtain a report of only the highest magnitudes, say from 90% to 100%, click in the From
box and then enter 90. The report is updated for magnitudes of 90% or higher.
Selecting the Criteria for the Timeline of Motion Events
Right-click the bar display to filter the bars by criteria. Bars in the chart reflect the criteria
selected. Percent is the default.
Figure 5-8 Detail of Selection in the Density Chart of a Report
The arrow moves as video is played.
Other Criteria
Percent. The amount of motion (magnitude) as a percentage of change.
Peak Energy. The highest level of instantaneous motion during the event.
Total Energy. Total cumulative motion during the event.
Duration. The length of each bar reflects how long the motion events lasted.
Motion Count. Total number of video frames that registered motion during the event.
Selecting Items in the Report
You can select one or more items in the report using either:
• The list of every detected motion.
• The density chart, at the top of the report (see
Zoom
The density chart of a selection of items can be zoomed for an enhanced view of the chart
between reports of motion detection (see
appear more spread-out and facilitates a finer selection, making it easier to double-click a
vertical bar to see the video excerpt associated with it.
Rapid Eye Remote View Operator Guide
Your selection in
the density chart
Items selected in either
the density chart or the
list of Motion events are
shown in both areas.
Figure 5-8).
Figure 5-9). Zooming makes a cluster of items
67