Playing Back Archived Data; Setting Up An Archival Server; Figure 11-3 Archiving Progress Bar - Honeywell Rapid Eye Operator's Manual

Playing Back Archived Data

Setting Up an Archival Server

Document 800-02951V3 Rev A
11/09
Figure 11-3 Archiving Progress Bar
Click Close when the archiving is 100% completed.
5.
Note Only one archival policy can run at a time (immediate or scheduled). If a
policy is running when a scheduled policy is set up to run, the scheduled
policy will be queued to run when the first archival policy is finished.
To play back archived data, you must first add an archival server with the Admin
application. Once the server is added, you then discover the archival sites with the View
application, select a site to retrieve data from, and then play back the video.
Note Video recorded at a very low frame rate (0.5 fps) may not play back properly.
Green blocks may be observed during playback. Increase the recording
frame rate to work around this issue.
Note Playing back clips from an archival server will be slower than playing back
clips from a retrieval session.
See the Rapid Eye™ Multi-Media Digital Video System Administrator
information on setting up Archival policies and Archival servers.
1. Right-click in the Archival Server tab of the Admin application.
2. Click Add on the menu that appears.
Rapid Eye Remote View Operator Guide
Note
Cancel, the current
archiving will stop, but
anything archived
previous to clicking
Cancel will be retained in
the local folder or
network share path
Server Location.
Guide, for more
If you click
125