Ending A Retrieval Session; Figure 3-14 Pal Resolution Gauge Example - Honeywell Rapid Eye Operator's Manual

Recorded Video
TIP!

Ending a Retrieval Session

58
The resolution gauge of recorded video may change if:
• A View Operator boosted the recording settings during a Live session.
• A Response schedule is in use, to automatically boost recording settings when events
occur. A response schedule is preset by your organization's Multi SA.
The back and forth on a gauge is shown for PAL in
moves to the right. When boosting stops, the gauge again shows the setting for continuous
recording.
Figure 3-14 PAL Resolution Gauge Example
Continuous recording
Boosted recording
Back to Continuous recording
If the resolution setting for Event recording is the same as for Continuous recording,
the Resolution gauge does not change. The dots may appear in different positions on
the gauge, depending on the resolution settings for Continuous and Event recording
(see Table 3-1 and Table
Do one of the following:
• Close a Retrieval from [site name] window.
- or -
• Click Disconnect on the Toolbar. This also closes other sessions (for example, live
video, retrieval, and alarm) at the site. On the Site action tab, beneath that site, the
Retrieval indicator is removed.
See also Recorded Audio
Messages from POS Hardware
29 for more details on live video and
schedules. A Multi-Media unit can be scheduled to suspend the recording of video feeds.
Figure
3-2, on page 57).
on page 111 for information on recording audio,
on page 131 for POS device information,
Scheduling on page
3-14. If boosting occurs, the dot
Live Data
Live Video on page
139 for more information on