Table of Contents
Advertisement
EN | 24
Note
The new IP address, subnet mask and gateway address are set after you
leave the menu. The camera reboots internally and the new values are set
after a few seconds.
Defaults
To restore all parameters (including IP address) to the factory defaults, press and
hold the Up navigation key for at least 10 seconds and then confirm. Allow a few
seconds for the camera to optimize the picture after a mode reset.
Note
Restoring the factory defaults may result in the loss of the IP connection.
If this occurs, change the IP address of your browser to the factory default
value. Only restore the factory defaults when it is absolutely necessary.
Dinion IP
| Installation Manual
Bosch Security Systems | 2006-05 | V2.0
- Quick Links:
- Configuration
- Defaults
- Password Protection
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Diniop IP - NWC-0455 and is the answer not in the manual?