Defaults Submenu - Bosch DINION XF LTC 0495 Installation Manual

Dinion | Installation Manual
XF
menu, the current area is displayed with the upper left corner flashing. The
flashing corner of the image can be moved with the Up, Down, Left, Right
arrow keys. Pressing the Select key moves the flashing cursor to the
opposite corner, which can now be moved. Pressing Select again freezes
the area and exits the area menu.
Video Motion Detection (VMD) submenu
Function Selection
VMD OFF, SIL, OSD
AREA 1, 2, 3, 4,
Select submenu
ACTIVE ON, OFF
MOTION Press SELECT to
reset indicator
SENS
EXIT
Note
If VMD areas overlap, motion is only detected in the area with the lowest
sequence number.

Defaults submenu

Function Selection
MODE
DEFAULTS
EXIT
Bosch Security Systems | 2004-01 | V1.0
Description
When VMD is enabled and the camera can
generate SIL (silent) or OSD (monitor alarm
generates on-screen message) motion alarms.
• It is possible to set 4 motion sensitive areas (per
MODE).
• Press SELECT to enter the area set-up menu.
Every area can be enabled individually by
selecting YES.
Indicates the peak of measured motion in the
selected area
Use the LEFT/RIGHT keys to set the SENSitivity
for motion to the desired level. Motion above this
level triggers alarm.
Return to Mode menu
Description
Select to restore the factory defaults. A
confirmation screen appears. Allow 5 seconds for
the camera to optimize the picture after a mode
reset.
Return to Mode menu
EN | 21