Connections Between Video Servers; Installation; Establishing The Connection; Connect On Alarm - Bosch Diniop IP - NWC-0455 Installation Manual

EN | 82

Connections between video servers

A camera can be used as a transmitter and a compatible MPEG-4 hardware
decoder with a connected monitor as a receiver using an Ethernet network
connection. This way it is possible to cover large distances with little effort for
installation or cabling.

Installation

Cameras are designed to connect with other VIP devices automatically with the
corresponding configuration. This only requires that they are part of a closed
network. Proceed as follows to install the devices:
– Connect the devices to the closed network using Ethernet cables.
– Connect them to the power supply.
Note
Make sure the devices are configured for the network environment and the
correct IP address for the remote location to be contacted in the event of
an alarm is set on the Alarm connections configuration page.

Establishing the connection

There are three options for establishing a connection between a transmitter and a
compatible receiver in a closed network:
• an alarm,
• a Web browser
• via the configuration manager

Connect on alarm

With the appropriate configuration, a connection between a transmitter and a
receiver is established automatically when an alarm is triggered. After a short
time, the live video image from the transmitter is shown on the connected
monitor.
Dinion IP
| Installation Manual
Bosch Security Systems | 2006-05 | V2.0
7