Maintenance 31; General; General Cleaning; Cleaning The Brushes - Formax 6900 Series Operator's Manual

9. 9. 9. 9. MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE
9.1 9.1 9.1 9.1

General

General General General
The IN-3 requires just a few maintenance activities for the
operating personnel. These are:

• general cleaning.

• cleaning the brushes.

• cleaning the moistening cloth.

• cleaning the sealing roller.

Disconnect the mains supply before performing
any maintenance.
The user must not attempt to service the
appliance beyond that described in this
operator manual. All other servicing must be
carried out by qualified service personnel only.
Please contact your authorized distributor.
Fig. 35
9.2 9.2 9.2 9.2 General cleaning General cleaning General cleaning General cleaning
The machine must be kept in proper condition by regularly
removing dust, paper remains, etc. Clean the sealing table
and rubber rollers when dirty. This can be done by using a
slightly wetted cloth.
9.3 9.3 9.3 9.3 Cleaning the brushes Cleaning the brushes Cleaning the brushes Cleaning the brushes
Clean the brushes when dirty or saturated with glue. An
extra set of brushes is provided. The best procedure is to
always soak one set of brushes and use the other set. In that
way there is always a clean set of brushes ready for usage.
To replace the brushes the transparent cover and loc must
be lifted. The loc can be released by pulling the release
handle of the loc (see Fig. 32). The brushes can be removed
one by one by pulling them straight off the brush holder (see
Fig. 35). When replacing the brushes, align the studs on
each brush with the respective holes in the holder.
Fig. 36
9.4 9.4 9.4 9.4 Cleaning the sealing roller Cleaning the sealing roller Cleaning the sealing roller Cleaning the sealing roller
The sealing roller A (Fig. 36) must be cleaned regularly with
a slightly wetted cloth.
9.5 9.5 9.5 9.5 Cleaning the moistening cloth Cleaning the moistening cloth Cleaning the moistening cloth Cleaning the moistening cloth
Clean the moistening cloth A (Fig. 37) and water tray when
dirty or saturated with glue. To remove the watertray the
transparent cover, loc (by pulling the release handle) and
sealing table (by pulling the locking handle) must be lifted.
Remove the bottle C and then remove the watertray B by
pulling it towards the hopper. Clean the water tray under
running water.
1-800-543-5454
www.officezone.com
Fig. 37
31/40 31/40 31/40 31/40