Formax 6900 Series Operator's Manual page 38

Optionally this function can be combined with split set. Then
document sets that contain a number of sheets up to twice
the actual overflow counter setting, will be folded and
inserted in the "small" envelope, whereby, depending on
the number of sheets, the set is temporary split in two groups
during the folding process. If a set exceeds twice the actual
overflow counter setting, it will not be folded and it will be
inserted in a "big" (C4 size) envelope. Via service, in the set
up menu an internal set limit counter can be set to a
maximum of documents that are allowed to be inserted, as
desired by the customer. If a set exeeds this number, the
AS-1A will consider the set as an overflow and will indicate
error 60.
To allow processing of thicker sets that are to be inserted in
"big" envelopes, the system can decide to temporary split
up these sets in two parts during the transport to the
collating area of the TR-7A. This depends on the number of
pages within the set and the value of the internal set limit
counter.
If the system encounters a combination of selection criteria,
it will react as follows: the 'big' envelope will be selected if
at least one these criteria indicates the use of a 'big'
envelope. The criteria are evaluated in the following order:
number of pages in a set, OMR hopper selection mark,
selective feed mark.
AS-1A functions extended for Automix AS-1A functions extended for AS-1A functions extended for AS-1A functions extended for
"insert arrow key"
Per job, service can set the AS-1A options for either "split
TM
set, Automix
or the combination of these functions. The
operator can then activate or de-activate this functionallity
using the key K, see fig. 11 page 5/12 of the AS-1A
operator manual. The function is active in case yellow led L
is on. In the job data menu the programmed settings will be
displayed below the AS-1A symbol.
Error 60
Error 60 means "Split set too big" and is an overflow
message in case documents are split up in parts. This error
can also appear in case Automix
exceeds the "set limit counter". The part of the set that is
located in the exit track can be removed by pressing key K
(see fig. 11 page 5/12 of the AS-1A operator manual).
TM
Now the AS-1A can behave in two ways:
• if the material is partly ejected but held by the exit rollers,
only these pages should be removed. Pages that are
located on the TR-7A transport track belong to the
previous set and should not be removed.
• if the material is fully ejected onto the TR-7A transport
track, so on top of the pages that are already on the
track, these pages belong to the same set. All material
should be removed.
1-800-543-5454
www.officezone.com
TM
is active and the set
37/40 37/40 37/40 37/40