Switching On; Entering The Personal Pin Code; The Main Menu - Formax 6900 Series Operator's Manual

5.2 5.2 5.2 5.2

Switching on

Switching on Switching on Switching on
Switch on the inserter using the power switch A, see Fig. 9.
If the AS-1A, PS-3 or franking machine etc. are part of the
system switch these on. Refer to the operator manuals of the
used modules if necessary.
After switching on the pin code screen or the main menu will
appear. In case the pin code screen appears, see section
5.3 for further instructions. In case the main menu screen
appears, see section 5.4 for further instructions.
Fig. 9
5.3 5.3 5.3 5.3

Entering the personal pin code

Entering the personal pin code Entering the personal pin code Entering the personal pin code
In Fig. 10 the pin code screen is shown.
Enter your pincode using the keys 1 to 6. If the code is not
correct, a warning "wrong code, try again" will be
displayed. This warning disappears immediately when a
key is pressed.
The pincode screen is not displayed if only the supervisor
code is defined. In this case the main menu as shown in Fig.
11 will be displayed after switching on the system.
Fig. 10
5.4 5.4 5.4 5.4

The main menu

The main menu The main menu The main menu
The main menu is shown in Fig. 11.
The "main menu" shows 6 different functions:
• go to job info screen (key 1).
• go to the "select job" menu (key 2).
• go to the "test run" menu (key 3).
• go to the "change counters" menu (key 4).
• go to the "settings"menu (key 5).
• go to the "entry to the job menu" (key 6).
1-800-543-5454
www.officezone.com
Fig. 11
7/40 7/40 7/40 7/40