Running A Job - Formax 6900 Series Operator's Manual

6.2 6.2 6.2 6.2

Running a job

Running a job Running a job Running a job
Start Start
Start Start
Test cycle
After all settings have been carried out a few test cycles can
be made by using the "insert one document" function, see
section 5.4.4 page 12 or see fig 27.
Automatic operation
When correct insertion is obtained, start automatic
operation by pressing the "Start" key.
When the "start" key is pressed (after switching on and no
other job is selected), the job information is sent to all
machines in the system. During this time an egg timer will
appear for about 10 seconds. When ready, the system
starts operating.
22/40 22/40 22/40
Fig. 27
If documents from a previous job are detected on the
transport track (TR-7A), these are transported to the
collating area of the TR-7A. The system then stops and
indicates that these documents have to be removed.
Remove and press the start key again.
1-800-543-5454
www.officezone.com
Stop Stop Stop Stop
Press the stop key to stop the system.
Job finishing Job finishing
Job finishing Job finishing
The system can be cleared during the running of a job or
after running out of address carrying documents.
To clear the system, press the clear key. The system will finish
all documents sets that have already been fed (e.g. to the
transport track) by the feed units. Then the system stops.
In case a transport unit is part of the system, see TR-7A
operator manual chapter 6.
With the 6900 Series, use the inserter clear key instead of
using the TR-7A reset key.
With the 6900 Series, remarks about the inserter "pause"key
are not applicable.
Stoppages Stoppages Stoppages Stoppages
In case of a stoppage, refer to chapter 7 and 8.